Chosen Solution
I was cleaning the pads in order to solder the new LCD connector to the board but i overheated while cleaning with the iron and lifted them. So what would be the best approach to fix it?
The missing pads 13 and 17 are connected to L2044 , L2042. I think i could do some bridging.
You’ll need to run a thin jumper wire from the closest (or most direct) connection point to the hole where the pad was. Ideally, you’ll want to loop the jumper in the pad hole and then fill it with solder so that it has a good contact patch. UV-Curable solder mask will help you fix the jumper in place so it doesn’t move when you solder the replacement FPC connector. Here’s an example (minus the solder in the loop):
