Chosen Solution I bought new battery for my MacBook Pro 13" Retina Display Late 2013 and the replacement was nice and easy and i were very carefull so i did not break anything. The new battery was working but now the keyboard is not working at all there is not even light in the caps lock button and yes i checked if the ribbon cable was loose but its just fine....
Chosen Solution I think maybe the clips at the top of the display (either side of the webcam) maybe be broked. The laptop therefore does not close. What can I do to fix this? Yes those clips break OR if you’ve had the top case off it may not be aligned correctly Replace the latch It’s a fair amount of work, and rather expensive. A soft case would add some protection and cost about 1/2 as much the part not considering the time to remove the broken one and install a new one....
Chosen Solution I locked my keys in my car on 2013 4Runner. It’s cold out and I did this on purpose because I have another key but that key won’t unlock it. Is there anyway I can use the key to get into my car? I tried turning the manual key but not sure if it’s not working because it’s so cold out or because that’s not possible. Have you tried the keys on ALL of the doors, including the tailgate?...
Chosen Solution Hi Guys, Recently I tried changing a new screen of my iPhone 5s 64GB Gold, The problem is I felt in the trap of Long Screws damage when screwing over the metal plate in place. Will buying and replacing the logic board (or motherboard) help me? Please help me guys. Thanks in advance chaythem, yes replacing the board will fix that. You can also try and have somebody rebuild the traces damaged by the long screw....
Chosen Solution Where can I find a LCD display for music keyboard YAMAHA PSR 5700? These folk will probably be your best bet for either getting it or finding out where to go: http://syntaur.com/yamaha_psr.html
Chosen Solution Hi guys, I have a macbook air to repair. The problem is the same as here: http://www.youtube.com/watch?v=BSpikNzb0… Looping chime. It even dont show logo of Mac OS. There just is a grey screen and looping chime until you place a finger on the button of power for 6 seconds. I tried to reset PRAM, SCM - nothing. It got even worse. Before I reset PRAM it loaded to Windows but keyboard or mouse did not response....
Chosen Solution Hi, I just bought a used 2012 Mac Mini off of eBay. The listing was for a 2012 i5 with 4 GB of RAM. I already owned an SSD and 8GB of RAM to upgrade the system. The listing stated that the Mac did not include a hard drive, but works perfectly. After opening the Mac Mini, I quickly realized that this was NOT the i5 version, but is the i7 server edition with the 2....
Chosen Solution Hello everyone, I have a mid-2011 macbook air that requires a battery replacement (it says service battery and its capacity has reduced to about 70%). Now, its startled me that the new 2013 macbook air, which has a 7150mAh capacity battery is not compatible with the mid-2011 model according to ifixit.com. I’m just finding it a bit difficult to understand why that may be the case, the capacity of my battery when it was new was 6700mAh and I thought that I would be able to replace it with the 2013 battery which is exactly the same physical size and shape....
Chosen Solution My laptop is unresponsive to any attempt to turn on. I did the SMC and NVRAM resets, I opened and inspected and found nothing unusual, I unplugged the internal battery and attempted to boot with just power cable, I’ve held the power button for extended period, I tried shift+ power long hold. Nothing has worked. When I push the power button, I hear barely a moment of electronic noise or fan creep and then it dies instantly but this is not consistent....
Chosen Solution My MacBook Pro will only run when plugged in. The battery was old, so I replaced it, but that didn’t seem to make any difference. It says that the battery is charged to 97 or 98 percent on the screen and the lights on the battery all light up when I push the tester button. Power cord, i/o board, and hard drive are all new within the last year....
Chosen Solution I have a mid-2009 15" MBP that will not progress past the gray screen at startup. When I press the power button I hear a normal chime, then nothing. No apple, no progress bar. The hard drive is an SSD I installed a couple years ago, so there’s no spinning to listen for. I have tried every keyboard combination I could find on the internet, but still nothing (recovery, single user, safe, etc)....
Chosen Solution Okay folks, new here. Hello! I have a 2011 MBP 15” display. It shut off randomly now I cant get the sucker to boot. The charger lights up green (full battery) Push power button the fans click on for like 5 seconds Front right hand corner white light comes on for 5 seconds then shuts off. I dont get any chimes or bings. I have tried every single button combo PRAM reset, Ive reseated the RAM now....
Chosen Solution The metering selector dial on my D700 is broken. The dial spins freely 360 degrees but the camera stays in the center weighted metering mode. Does anyone know if it is possible to repair that part and, if so, any resources on how I would go about it? Thanks Hi @simonc137 Here’s the service manual for the camera. The metering mode dial unit (part ID #B782) is shown being removed on p....
Chosen Solution Ive got a iPhone 5s that ive completed a water cure on. The charging port flex and battery have been replaced. My question is that i have a extra tiny peice that should go someplace with the charging flex. it has 2 holes in the cable for screws to go into with the charging flex but i dont know where it lines up to put the screw in. Any help would be appreciated!...
Chosen Solution Hello, my question is regarding the iPhone 7’s Loop Disease. For any micro soldering geeks here on iFixit, here is my question for you: If I buy the soldering workstation on iFixit, does it have everything I would need to get the job done (besides needing a heat gun)? Thanks! To do an Audio IC repair, you need both the soldering station and hot air station. The hot air station will allow you to remove, reball and solder the audio IC in place....
Chosen Solution Craftsman YV4000 Riding Mower - This is a mower used for mowing a cemetery. During use a problem occurred. The bolts on the transmission came loose. After service it was found that the mower went slower in Forward than reverse. Shortly after service the shop closed. I checked for some kind of adjustment on the rod which goes to the transmission but found nothing. Has anyone any idea what could cause this?...
Chosen Solution I have a 1984 Suzuki Moped and it does not get any spark? I have replaced the Spark plug and still no spark? Any help would be great Ray, couple of things that can cause this condition. First off, download the service manual for your moped from here. It will show you how and what to check.Reasons for no spark can be: “Poor contact between spark ply cap and high tension cord Broken or improperly connected ground wire Defective engine kill switch Poor contact of ignition switch Broken or short circuited ignition coil defective wiring among stator, PEI unit and ignition coil Defective PEI unit” Hope this helps to get you started....
Chosen Solution my iPhone 7 home button not working , one of third party technician was tried to replace u10 chip but unfortunately while removing damaged my upper flex ( attached steel round button) and also he was failed to re install u10 , now my iPhone home button not having chip and also touch id not working just i wanted to know the confirmation that if replace the u10 my touch id will work again or not ?...
Chosen Solution Hey guys, after 3 years my battery died. I bought a new one on ebay and replaced the old battery(done it before, also with a different 4s and it worked out). It charges now but the phone stays in dfu mode(charge+itunes symbol on display). I tried to update it with Itunes but thats not working either(Error 21). Reset is no option, because my latest backup is outdated and I dont want to loose my data, pics etc....
Chosen Solution I dropped my iPhone 3g the other day. Now it keeps losing service off and on sometimes it gets service and I can get text messages and make calls, but then loses service in like 30 seconds even though I haven’t moved it. My phone is also jail-broken for t-mobile. Please help me out; my wife is super mad because I just got this phone after I broke my other one....
