Chosen Solution 2001 Mazda Tribute while pulling into the parking lot my car unexpectedly shut off but it will still start concern why did it shut off unexpectedly Without actually seeing the car its hard to say with any certainty but here are a few things you can look at . The fuel filter may be getting plugged and with a sudden drop in rpm it starved the engine for fuel and stalled ....
Chosen Solution iphone was in water proof case but had a leak phone got wet and now will not turn on michele, the major issue you will run into is corrosion damage. Salt Water will get your components to corrode very severely. The very first thing I would do is to disassemble it by following this guide. Take a careful and close look at all components and connectors. Truly assess the damage....
Chosen Solution Hi. I need to identify where this part goes in my iPhone SE. It sprung out whilst I was taking the phone apart to try and repair the motherboard for water damage. Phone reassembled without it but not working. Might be something else but would like to put it back correctly many thanks mike It’s a washer that fits under the motherboard at the top of the phone. It goes under the red circled screw in Step 30 of this guide: iPhone SE Logic Board Replacement
Chosen Solution So my phone got wet after it had a crack in it and was badly water damaged, I managed to replace the screen after a week of letting it dry out and the screen looks fine but now when I turn it on it’s stuck in a boot loop, if I try a hard reset it just stays off but when I try and turn it back on again the boot loop starts back up....
Chosen Solution My phone had issues with the charging port, so I replaced it… However, after making this change, my phone is no longer able to detect my carrier… Everything else is working normally (including my new charging port). If I reinsert my SIM card I can see my phone carrier for around 10 seconds, then the “No Service” is back. Toggling Airplane mode will always show No Service after searching....
Chosen Solution Dropped my phone a few feet up, and since then half of my screen display is just black, making it near impossible to use my phone. I have tried the hard reset but nothing has changed. The phone was bought directly from Apple, and hasn’t had many other problems. Thanks for reading, I would really appreciate some help fixing my phone. This response is late but hopefully it can help others....
Chosen Solution G’day everyone, So a family member recently gave me their old and broken Macbook Air (Early 2008) simply because I like to tinker with computers and thought I might be able to get it working. So I’ve had a look at the computer (an original early 2008 1.6 GHz Air) and I’ve found that the logic board is toast. My question is this; seeing that the early and late 2008 Macbook Airs are very similar, would it be possible to purchase a late 2008 macbook air logic board (With the Nvidia GPU) and put it into this old computer to bring it back to life (with El Capitan instead of being limited to Lion)?...
Chosen Solution The compressor in my inexpensive, simple GE fridge is about to fail. It’s a GTS18FB and the R134a compressor is DC57C84RCU6. I’m confident it’s the compressor. I have previously replaced the startup capacitor and fixed this fridge. I could play audio for you and you’d hear it—a big clank when it starts up, a loud whirring while it’s running, and a clank when it shuts off. It’s still cooling fine though, so I have days / weeks to fix it....
Chosen Solution I have an iPhone 8 that needs a battery replacement, and opening the device also means replacing the display adhesive. I have 3 leftover iPhone 7 display adhesives, and I was wondering if they would fit on the iPhone 8 so I don’t have to order a display adhesive. Thank you so much! just from looking at the 2 adhesives, it doesnt look like they are interchangeable. look at this iPhone 7 Display Assembly Adhesive & iPhone 8/SE 2020 Display Assembly Adhesive sorry my friend
Chosen Solution i was doing a search for what causes the ylod and i found a web site http://boardsus.playstation.com/t5/PlayS… in case you have trouble finding it the site says that this person had the ylod right after a firmware update and they said they took the hard drive out and made it a slave on another computer and formatted it then re installed it and did a firmware update and that fixed it....
Chosen Solution I have a JVC vcr/dvd player that shuts itself off after a few seconds. I have repeatedly followed the instructs to no avail. I am hoping to find a solution here. Try a different outlet and without the use of a power strip. The power supply could be failing. Also when it comes on, try to insert a disk. It may have an auto power off feature if no media is present....
Chosen Solution Hello, looking for a replacement middle rod for this model fan, so I can connect the fan and the base. Anyone have any idea where I can purchase the correct piece? No luck finding it so far. Hi, Try contacting Kaz USA Consumer Relations to find out if there are even any spare parts available for your model fan. If there aren’t any available, it’ll save you hunting about for non existent parts....
Chosen Solution SONY VAIO PCG-712211W when i turn on my laptop white screen nothing else from bios till window load white screen only………. i tried on my external monitor works fine no mistake… i scan my full system no virus at all……………………… i tried disconnecting and reconnecting the display cable of my lcd screen several time but nothing works white screen only………… but one thing i did’t get it…………………… my lcd back panel circuit board gets overheat when the display cable is connected well i disconnect it heat goes as cool………………………....
Chosen Solution So a couple month ago my around 7 year old Lenovo g560 decided to just die infront of me. The problem isn’t with the battery, I think. When plugged in, nothing happens. When left to charge and then turned on, nothing happens. I’ve tried some YouTube repair guides, but again, nothing happens. Primarily I’d just like to save the hard drive on it. If someone could tell me if the laptop not working has corrupted data or not I’d be thankful....
Chosen Solution I am trying to replace my defective LCD display. I’m not going to go through the trouble of trying to locate the problem and fix it locally. I noticed that the model no. for the Macbook Pro 13" Unibody Mid-2009 is 661-5232. For the equivalent Mid-2010 model, that number is 661-5558. However, ifixit.com and a number of other websites sell complete LCD displays for mid-2009 and mid-2010 models as one type of display (as opposed to the 2011 and 2012 models)....
Chosen Solution Hey everyone, here’s whats happened. I replaced my iPhone 6 screen for the second time and everything went well, the phone worked perfect. After a week or so the display would sometimes glitch out and sometimes even go completely black. This happened very randomly and I discovered (by accident) that whenever it did go black the only way to make it come back was to drop the phone face first onto something relatively solid....
Chosen Solution My phone dropped in water and now everything seems to work except touch lcd color are good but it is not responding to touch what could be the problem? Like you said. What wrong is that iT dropped in water. You need to get iT cleaned asap. My guess is there is water on you board or connectors. Dont take iT light get iT cleaned.
Chosen Solution I am having more and more of my customers come in believing they have viruses. They are almost stopped from web browsing because of pop-up ads. Most have MacKeeper installed. What I am looking for is the best ad blocking software. What have you tried and how effective is it? UPDATE 5/19/15 This problem is becoming much greater with my customers. The anti-virus programs are not blocking sites like “pchelpandsupport....
Chosen Solution Went to take my sister to practice saw that my left low beam wasn’t working. Bought a new bulb and replaced the left one I then turned my car on and now both low beams have stopped working the high beams still work fuses seem fine Check that you have the light seated properly in the socket
Chosen Solution hello my mac mini from late 2014 is dead, after pressing the power button it does nothing, I already tested the power supply with another motherboard and it works, does anyone have any idea of the motherboard components that should I check? here I upload the photos of the motherboard: Here I send the photos of the area where I smell burning, this happens when connecting the power cord to the power supply:...
