Chosen Solution Hey guys, got an iPhone X water damaged with 4013 error, ruled out common issues like the speaker flex and changed housing too. Same issue occurs. Phone doesn’t enter DFU mode, and gives me 4013 error on iTunes. I am suspecting a bad NAND Flash chip so i wanted to know how do I remove the nand? As I’ve never done a NAND fix on a Sandwich Layer Board....
Chosen Solution I have a MacBook Pro 13" Retina Display Early 2015 - Battery Model A1582 and the battery is swollen slightly, needless to say I want to remove it and dispose of it as soon as possible, but don’t have access to an adhesive remover (at least in a timely manner) so I will need to slightly heat the cells somehow to release the adhesive. I have read that it is unsafe to heat up swollen batteries, so I wanted to check before proceeding....
Chosen Solution Hello, recently I have replaced my battery on my iPhone 7 Plus. I’ve put the adhesive between the screen and the rear case. I’ve also sucked lightly from the SIM tray hole and it formed a weak vacuum. Is my iPhone still water-resistant after the battery replacement and how can I test that my iPhone is sealed correctly? Forget about water resistance after you open it, unless the replacement would be done in clean factory conditions and with a perfect new housing and gaskets everything you can get a moderate splash resistance, that’s all....
Chosen Solution Hi I just replaced my battery on my MacBook, with a new one, kit from IFIXIT Battery works fine, lovely kit to do the replacement. But now it says that the battery manufacture date is 2012-10-24……. Thats even older than my original! I just replaced. Can this date be changed? Regards Henrik Hi Henrik, If you purchased this battery, then the manufacture date is likely correct and cannot be changed....
Chosen Solution Washing machine starts, then when it’s time to start spinning, it stops. LED displays “lnt” (sm L) or it’s “int", not sure which. Reset machine, now I’m getting the “F21" code. I know this code, would like to know if “lnt" means lint. These initials only come up after machine has been unplugged for awhile and I would try to start a wash cycle, which usually stops and flashes “F21”....
Chosen Solution Okay so last year my macbook fell from a table straight down to the floor. The tip of my macbook’s lcd is dent now due to that fall but there were no lines or whatsoever. a year later probably 3 weeks ago, I woke up as usual and when I open my macbook I saw this horizontal line stretching from the tip of the right side of my macbook screen (the dented one) all the way to the bottom left....
Chosen Solution My daughter put in a code and now I can’t get into it she is only 5 and don’t even know what she did try some of the things mentioned in this answer or in other posts with the tag screen lock code If you have all your music on your computer, you can restore the iPod and it will erase the code. It will also erase the entire iPod, so make sure you have all the music first....
Chosen Solution I have an 27" LED Cinema Display and when i connect it to my Macbook Pro 5,1 and connect the power supply i can only see the display on very very low light, i have tried changing the resolution and the light in the system preferences The backlight with this model is built into the LCD display assembly and draws power, through a separate backlight cable, directly from the device’s power supply and depends on the logic board to provide backlight information....
Chosen Solution Hi, The following is just my personal opinion. If you don’t like Win 10 then stick with Win 7. Win 10 is the result of all the improvements that were first attempted with the introduction of Win 8. Most of the problems in Win 8 were resolved and Win 10 is the result. It also has better built in security than any previous Win OS. You need also to bear in mind that support for Win 7 ends in 2020, Win 8....
Chosen Solution Hey everybody, I upgrade my iMac (Blade SSD + SSD + RAM) and I have a problem. My iMac doesn’t start up properly but only if I press PRAM reset at the start and then he starts properly. I exclude it’s an hardware problem, but I see it like a software/firmware problem. Suggestions? Go under the Apple icon to System Preferences > start up disk > unlock it > select the start up disk and close and restart....
Chosen Solution I had some repairs done to the iSight connector on my Macbook Pro 17 circuit board. I noticed the left copper wire brushes up against those two metal spikes poking through. Do they have to stay touching or do they look like placeholders? I can solder the wire to those spikes, they bounce off from time to time. I’m the tech that did this repair!!!! Those are enamel coated wires....
Chosen Solution main phone works but the other two dont Hi, Have you tried plugging the main phone into the two other phone sockets to see if they work? Have you tried the other two phones by plugging them into the main phone socket to see if they work? Once you have proven which phones and sockets work and which ones don’t, in the case of faulty sockets you will need to check the wiring....
Chosen Solution Hi, The issues you are describing are mostly due to A/ poorly seated screen cables or B/ to poorly made or damaged screen cables or C/ to very poor screen quality. It’s usually A and/or B. Therefore a new good quality screen assembly properly seated in place will solve your issue. Be extra careful when connecting the screen cables and when re-installing the shield that holds the cables in place: pulling on the screen and/or the cables can permanently damage the screen assembly and cause the issues you are describing....
Chosen Solution I have an iphone 7 plus and its completly destroyed, but the motherboard still works, and I found an icloud locked iphone 7 plus on facebook marketplace for $60. If i put my motherboard on that iphone, will it work? And do i have to look for an specific model number or something like that? Thanks in advance and sorry for my crappy english. It doesn’t matter what model number the iPhone 7 plus is, it will fit into the housing without a problem....
Chosen Solution A couple of months ago, I plugged one of those lightning fans into my iPhone 6s (yes, I’ve heard of iPhones dying because of it, but I was silly and did it anyway). Anyway, a couple of days later, I really started to notice my battery would drain quickly, and my phone would heat up, as well as only certain chargers would work with my phone. This lead me to believe that I had ruined the battery, so I proceeded to order another battery for the phone....
Chosen Solution What could be the problem if my iPhone 5 screen replacement doesn’t fit? I notice that the glass is separated from the actual frame of the screen replacement but even still if that was glued or fastened properly, shouldn’t it still remain flat? I think the fact that it still sits awkwardly outward like that might reveal a deeper issue. Thoughts? Thank you. See Photo Hi everyone, it has been quite awhile but I am sorry to say that that phone was a lost cause, however, I ran into the same exact issue on another phone and realized that the front rear camera and earpiece chord were positioned underneath the aluminum plate on the digitizer when really the chord needed to be on top of it....
Chosen Solution Hello everyone! so my iPhone is stuck on the apple logo i’ve tried to restore it via iTunes but everytime it’s extracting the firmware my iPhone go out of dfu mode. so i cant restore it ! Any solutions please? i’ve tried to download it manually but it’s still the same thing, extracting takes too long and my phone go out of dfu mode…please help! thank you If you can’t restore you have a hardware issue, hard to tell what it might be without any previous history of the iPhone....
Chosen Solution Hey, so I bought an iPhone XR. It has a black line going through the middle of the screen, so I assumed all it needed was a screen replacement. The person I bought this from, told me it has a password and just needed restored in iTunes. Which I was fine with. But, it won’t connect to any computer. It will charge perfectly fine, but won’t connect to my Macbook, PC, or Mac Mini....
Chosen Solution ther screen is busted in my toshiba a505 laptop i have another screen out of another toshiba which is a 105-s2236. I’m wondering if this swap can be done and if so how hard it is for a novice Take a look at this video to see if you would like to proceed. https://www.youtube.com/watch?v=6QSNo0EH…
Chosen Solution My Bose SoundSport earbuds are about 18 months old, and I’ve noticed the battery performance is decreasing. These are $120 headphones. Is it possible to remove the housing and replace the battery? I was able to find battery replacement parts for them on ebay. It appears that the battery is soldered to the board inside so if you are comfortable soldering you should have no trouble. I couldnt locate a teardown guide on here but youtube has a video doing exactly this....
