Chosen Solution Hello, I do have an iPhone 6s here, which won’t power on. As this is a too generous description, I did some measurements before asking here. First thing was to replace the battery with a working one. But this doesn’t changed anything. Although the original battery reads 3,7V and my known working one has about 4V. Then I recognized that the phone is taking current from the power supply....
Chosen Solution Hey guys! Very very strange issue actually. I repair iPhones since years, nearly saw everything during that time but not that. I got an iPhone 6 with a battery which was bloated a bit. It worked well so far, but pushed at the back-side of the LCD. So we needed to replace it. I still had a replacement battery onsite (3rd party) and tried it: Battery charging stays at 1% for hours....
Chosen Solution My iPod is almost completely non-original now. At first I thought the logic board was bad, so I replaced it. At that point it would come on when plugged in, but the lock symbol was on and the click wheel would not respond, even when the hold switch was off. I figured no biggie, since I control it through my car stereo anyway. However, once plugged into the car, I could choose the artist and song, but it would continuously cycle through the songs without playing anything....
Chosen Solution Hi all, Does anyone know if it is possible to change the factory 2.93 GHz i7 from a mid-2010 27" iMac to a 4.0 GHz i7 8700K with LGA 1151 slot compatibility? I am looking to do this since I use the machine for a lot of HandBrake encoding and am looking for a speed boost. Would it be feasible? Here is a good reference on SkyLake: Wikipedia - Skylake_(microarchitecture)....
Chosen Solution My iPhone has taken water damage, It wasn’t in the water long. The iPhone seems like it wants to turn on, but it won’t go past the “Apple” logo as its turning on. The screen has Gray lines going across the screen when plugged up. I took the phone to a “Dry Box” but the issue is still the same. It has been about 5 days since it got wet and is still not working....
Chosen Solution so i took my iphone 8 plus into the shower and it was fine. then i took it out and blew it out with canned air. while i did that i was holding the screen. i felt the screen bulge out as if it where filling with air. i am very worried that i may have broken the speakers or the waterproof seal. Gday Pigg, the iPhone 8 isn’t waterproof to begin with, Its only IP67....
Chosen Solution I have macbook pro 13 it starts overheating after 15 minutes of use early in the morning ,I have placed it above a cooling pad even then the fan rpm shows 6240 what should i do I am from INDIA I have replaced the hard disc twice should i go in for the current version please advice thank you Narayan lakshmanan INDIA Cooling pad is worthless because apple trash have no bottom ventilation....
Chosen Solution I get f dl error code. machine clicks 6 times and beeps. Thought I fixed problem after cleaning filter. It must be door lock switch, I’m guessin… CAN ANYONE HELP? William Semas, as you already figured out it is not related to the filter. These are the errors for error code F/dL Door Lock Error Condition A Door Lock Error occurs if the door cannot be unlocked. It will try to lock it 6 times before displaying the error....
Chosen Solution HP 250 G4 working and there is no display. Please HELP… LCD and connector everything is fine. Hi, Have you tried repeatedly pressing the screen image display key (5th key from left, top row - rectangle symbol with line either side) toggling between laptop, external and both to see if the laptop display comes on? Try connecting an external monitor to the laptop’s HDMI port and check if you get a display on it....
Chosen Solution It one year im using my iphone just yesterday I noticed my screen right side slightly come out also the left side ( more on right) I charge my phone with not original charger i search just found its battery issues is that correct? And if yes after I changing it will back inside?! Your battery may or may not of swelled up, if it has swelled up, this will cause pressure on the screen causing it to pop out from the frame, you would need to replace the battery if it is swollen....
Chosen Solution Does anyone know how to fit the logic board loud speaker spacer in an iPhone 5s. Please go to the link to view the part. http://www.ebay.co.uk/itm/Apple-iPhone-5… I’m not really sure what you mean by this question. If you are talking about the bottom speaker it simply slides under the logic board then is held down by a screw. Make sure you route the antenna cable on the side of the bottom speaker before putting it in fully....
Chosen Solution I just installed the kit. i installed the 500 gb hdd under my new ssd and when the 500gb is working im hearing working noise, not loud but before i installed the kit, there was no noise. Very odd - You could try placing some felt under the screw mounts (limited just to the mounting areas). Did you put the rubber bushings back on the HD correctly?
Chosen Solution I installed a Samsung 120 GB harddrive from iFixit. Removal and installation was easy with iFixit. The previous drive was bad. I erased the new harddrive with Disk Utility and selected the recommended MAC OS Extended (Journaled). The new drive shows with the named partitioned file. I installed the original Macbook Air installation disk 10.5 in the Macbook Air external Super Drive. When I attempt to install I get the above message....
Chosen Solution Hi Everyone, I have a MacBook Air 13 ’’ Model A1466 EMC2925 It does not turn on, and when charging, the MagSafe stays at orange. I have left it over a day now, and nothing. I suspect the issue is the battery, but I’m not totally sure. Is there a way to prove it? Best, I have the exact same issue on a client’s Macbook Air (13" 2015) : the charger goes orange even when the battery is disconnected....
Chosen Solution I have a mid 2015 15’’ macbook pro that I both in april 2016. For about a month the screen has been pretty annoying, flickering every once in a while. Now it’s worse, it freezes while using, flickers and ultimately turns grey with thin vertical lines. At this point I also have to shut it down manually. Any help on how I can get this fixed? It obviously had to happen a month after my warranty expired....
Chosen Solution My mac was stepped on and now the disc us stuck inside and the screen is broken is it worth trying to fix and if so what do I have to do? I have never fixed one before and can’t afford a shop Sarah, A screen replacement won’t be easy, though it’s totally possible! You haven’t told us what MacBook you have, so prices for the screen (and CD drive) can range fairly greatly…expect to easily pay over $200 (maybe over $300) for the parts to do this....
Chosen Solution RE:Lenovo Edge 2-1580 QF 80QF0004US Can I disconnect and remove the screen lcd, digitizer, camera and anything connecting the screen and top lid to the keyboard section and just use the keyboard and guts underneath as a desktop? I use as a desktop now but with the screen being broke I would like to just take it off entirely for safety. I don’t feel worth it to try and fix....
Chosen Solution I have an old MacBook Pro with a removable battery, and just bought 2 non-Apple batteries (since Apple aren’t making them anymore). I travel about a bit, and wanted to extend my time between charges. So I now have 2 new batteries, and the old one which works for about 3 hours still. I have been using Watts to tell me when I need to run down and recharge the battery, but this app doesn’t recognise multiple batteries, so is not going to be all that useful when I swap around between 3 batteries....
Chosen Solution Hey guys recently my SE stopped turning on because it wouldn’t charge, i’ve had the phone for about 5 years since so i replaced the battery and the charging dock in one go battery worked fine but every time i install everything it boots up and charges fine but the headphone quality is very jank, and both bottom and headphone jack microphones wont work; tested all with voice memo thinking my lighting port replacement was a dud or maybe i wasn’t properly grounded the first time i ordered another lighting port replacement and the same thing happens Whats going on is the grounding washer on the cable by the headphone jack the cause of this issue?...
Chosen Solution Hi, I’m having an issue with iphone 8, back light but no display. I have a few questions. Can you tell me what readings I’m supposed to be getting at test points TPO533, TPO534 and TPO535? With just battery connected and phone on in voltage mode multimeter I’m getting (TPO533) 0.05v, (TPO534) 0.05V, (TPO535) 4.14v. But when I switch over to diode mode I get (TPO533) 0.629v, (TPO534) 0....
