Chosen Solution I am receiving an F7E1 error code on a Kenmore 110 series VWM drive top load washer. When I run the automatic automatic test mode diagnostic, I get good cold water, good hot water, good both water, good agitate, and good drain. I hear the shifter, but then I do NOT get a spin. I confirmed all of these with the manual test mode - my problem is BOTH the low spin and the high spin....
Chosen Solution Hi the left ear peice has stopped working suddenly. No sound and the noise cancelling not working either. The right side is fine so not sure what is going on.. These are just over a year old and working perfectly yesterday.. Hi, The left speaker (earphone) is connected to the “tip” of the connecting cable. Ensure that you have fully inserted the cable at both ends. Also try plugging into another source of music etc to see if the problem still exists, If inserted OK and another source makes no difference try the following: With the headphones playing, very gently flex the cable where it leaves the plug and listen if the sound comes and goes in the left speaker....
Chosen Solution Where can I send my JXD s7800b for repair? The left toggle is broken. Hi, I don’t know where to send your tablet for repair as you don’t state your location and ifixit does not do repairs. This website is answered by volunteers trying to help you to fix it yourself and if you cannot, what may be another option. You may be able to fix the problem yourself, if the joystick is physically broken or not functioning correctly by replacing it....
Chosen Solution My washer starts without a problem, starts to fill in with water. At the moment about 5 minutes from start it drains the water out and IE error code (not filled with water) displays. What can I do? Hi @ajovaisa , You don’t state the model number of the washing machine but here is a link that still may be relevant to your problem
Chosen Solution The bottom half om my screen is covered in lines, I have tested with an external monitor and that works fine so I believe its the cable. I have reseated the ribbon connector inside with no luck, Can I dis assemble the display so I can check the cable inside the screen? Hi Joe, welcome to iFixit Answers board. Yes verifying the LVDS connection to the LCD is the next troubleshooting step but I’m afraid the LCD panel might be faulty....
Chosen Solution well i have been having problems with my iphone 4. my iphone will not turn on, so i opened it up and saw that the black holder that the battery cable attaches too had broken off. i am wondering what i need to buy and i will install it. That is your battery connector. You ripped it off the board when trying to remove the battery. It can be fixed, as I have done it before....
Chosen Solution What is the cost of a Solid State HD for my Mac Mini? You can add one using this guide which also lists SSD options at the start: Installing Mac Mini Late 2012 Dual Hard Drive Kit
Chosen Solution I read through several threads and guides here, but I’m a little stuck on getting a Mac Pro 4,1 (single processor) to boot up. After my machine stopped working one morning, I tried a restart or two where it rebooted and ran for about a minute before crashing. Then it would not boot while hot. So not yet realizing what it could be, I did a few of the usual things such as reset SMC, PRAM, change the pram battery, clean the memory and clean out all the dust....
Chosen Solution Hi iFixit! Thanks for the great site. I have fixed and repaired a lot of stuff using your guides. Clear and easy to follow! Do you have any solutions to the wide spread MacBook Pro 2011 GPU Glitch? http://action.mbp2011.com/ We are a lot of affected user that would love to get our MBP’s up and running again. Are there any hardware repairs or replacement one can do? Here’s a hack that sounds plausible but havent tried myself: http://www....
Chosen Solution Hey folks, I have a GE Profile microwave and it started arcing. I took it apart and pulled the magnatron. It was arcing between the top of the magnatron tube and the shielding on the microwave. I tested the diode and it is bad for sure. My main question is did the magnatron possibly go bad and arc causing the diode to blow, or would the diode going bad cause the magnatron to arc....
Chosen Solution I dropped my iPhone on the top. Was in a good case. No physical damage to the phone. The problem is it wont pick up my voice unless using the speaker phone, when using phone, record, or anything. Siri no longer has a voice either. when playing music sound comes out of the bottom speakers fine. I cannot find a mouthpiece mic in any parts list for the 4s....
Chosen Solution My iPhone 7 is randomly unresponsive and works fine after lock and unlock. Any idea of what causing this issue ? And repair guide ? Your phone could be suffering from a damaged or defective screen. If your phone has suffered drops or other physical impacts, you should consider trying a replacement scree. You can find one here and the repair guide here. Update to the latest software version available for your device....
Chosen Solution I have an iphone 8. The screen broke about a year ago and I have tried replacing it twice with 2 iphone 8 lcd replacement screens assuming the first screen was bad. Neither screen works on the phone. So i had a 7 screen that looked very similar and figured i might as well try it.. it works but doesn’t fit quite right. Anybody run into this? Model number is MQ6L2LL/A...
Chosen Solution I tried to update my iPhone 8 plus to the public beta of iOS 13, but my phone died at the end of the update. Is there any way to get it out of bootloop? P.s, my lock button is broken. The phone is in overall bad shape, but I just wanted to get it to turn back on. Thanks. If you have a copy of your data, you could do a DFU Restore of iOS....
Chosen Solution Hi, I recently changed the back of my 3gs. it all went well and had absoluetly no problems what so ever. Got it back in one piece no problem. Now when i start the phone up it freezes shortly after the pincode screen is reached. If i enter the pin it will freeze as soon as the last correct digit is pressed. If i leave it locked, the swirly wheel thing eventually comes on....
Chosen Solution I’m trying to connect my new iPhone to iTunes but it will not install the drivers. I get an error message saying cannot connect iTunes because the device timed out. However my iPhone is up and running. Mel, make sure that iTunes and the iOS Software is up to date. Then disconnect the phone. Do a hard reset by holding down the sleep/wake button, and home button, until the phone completely turns....
Chosen Solution So here is what I have done: phone WILL charge via cable and wall outletphone WILL NOT charge via cable to USB (tried two laptops and one desktop)phone WILL NOT connect to PC (tried two laptops and one desktop)other phones work will the 3 PCs and the cable with no issues So all this lead me to swap the charging port/connector with another known good iPhone6 that had a bent case and cracked screen - so I figured I’d get one backup phone out of the two....
Chosen Solution Like I said in the description, my iPod classic only works when it is docked to my Sony ICFCS15IP Alarm clock dock. But as soon as it is removed from the dock, the iPod cuts off and it is completely unresponsive. When try to plug it into my computer using the 30 pin connecter cable, the screen flashes the Apple logo on and off. Is this a battery issue, logic board issue, or something else?...
Chosen Solution The ipod charges up but when I come to turn it on it just clicks about 3 times and doesn’t do anything else apart turn off, can anybody please let me know what is wrong and what parts I need to replace ? I am thinking hard drive but not too sure if this is what is casuing the issue. thanks in advance for your help. Damaged hard drive....
Chosen Solution Hi, I’ve bought a second hand iPhone 6 plus and when receiving it wouldn’t charge. I’ve previously opened up plenty of iPhones to replace screens and batteries, so i opened up the iPhone only to see that the screen already had been replaced (non OEM part). Is it at all possible a bad screen is the cause? or should I look elsewhere? Fun fact: I can charge the phone on an official docking station, but not with the cable directly plugged in the phone....
