Posts

Chosen Solution The left fan makes noises when it runs at around 1800-2400 RPM. The frequency of the noise decreases as the RPM increases. Here’s the link to the recording https://instaud.io/3ep1 Get a small soft paint brush and a can of can’ed air. Follow this guide to take the bottom cover off MacBook Pro 13" Touch Bar Late 2016 Lower Case Replacement Be very careful when prying as you can damage your logic board if you push any tools to far in....

Chosen Solution My Macbook 2011 i7, wont turn on when pressing the power button. There is no chime, fan or any indication its alive. Theres greenlight in the magsafe when plugged to machine but no orange. I’ve tried the ff, reset SMC, holding the power button for 10sec, unplugged the battery and pressed and hold the power button for 10sec, and press again, but no luck. Ive tried to power it up also thru power pads direct in the logic board, but it ddnt light up....

Chosen Solution I have many white Macbook models and was wondering what the maximum capacity hard drives they can take. The largest I have personally put in one is a 1 TB. OWC shows a 2TB for the 2007 MacBooks: https://eshop.macsales.com/MyOWC/Upgrade…

Chosen Solution Hi, My MacBook Pro 16” from 2019 died because of a SSD short circuit. I had and independent reparator look at it and they swapped out the dead SSD chips with new ones (they unsoldered the older one and soldered new ones). Now the Mac does accept power (touch pad clicking) whereas it did not before the ssd chips were replaced, but they told me due to Apple’s T2 chip it wouldn’t boot....

Chosen Solution My 32” Sony LED Smart Tv have a problem in which the menu button keeps on appearing and disappearing by its own and sometimes changes the button from HDMI1 TO HDMI2 or TV Screen to Screen mirroring ,volume button increasing etc all by itself. What will be the reason and what will be the repair price? Any help please. I got the same problem and I fixed it by removing the cable between the TV buttons and the motherboard, moisture or something like that penetrated to the buttons and started messing with everything, if you want to keep your buttons then first you need to remove the cable to make sure that the problem is located there and clean them up....

Chosen Solution I used it last night, and I was able to shut it down properly. Since I know the battery level is low, I charged it. As soon as the red LED turns green, I pulled off the charger plug. The next day when I opened it; it won’t turn on at all. I plugged the charger, the charging led was lit, but pressing the power button won’t turn on the unit....

Chosen Solution Hi guys, does anybody have known good diode readings for the J6400 charging port For an iPhone 8? or even a photo of the ibridge that shows what the diode readings should be on the J4101? would be very much appreciated if anybody could upload. UPDATE: I have discovered that what is causing the boot loop is the dock connector, When I unplug it, the phone turns on normally, no issues at all....

Chosen Solution iphone was wrapped around a slightly wet towel and now the bottom left of the screen does random taps or when i tap the bottom left it would tap somewhere else….i have taken it to get the screen replaced and the screen is fine but dont see what the problem is…the phone shop said maybe a software issue The most likely scenario is that moisture got into your phone....

Chosen Solution Hi Guys! My bought an iphone X like a year ago and i’ve have had to replace the screen like three times already. All of the times the fall that caused the screen to crack was about like one metre. Either I’m extremely unlucky or theres something funky elsewhere. I’m planning on replacing the screen myself this time as its freaking expensive to repair it but im wondering if there’s something else that might be causing the screen to crack easily?...

Chosen Solution I dropped my ipod nano 5th gen. When it is docked, everything works great, but it powers off instantly when unplugged, and when it is re-docked, it boots up as if it shut down due to battery failure. It will then indicate that the battery is charging, but even when I wait until it says the battery is charged, it will still power down when undocked. The battery was in great shape prior to me dropping the thing....

Chosen Solution I work at a repair shop, and for a while we have been debating what you should tell a guest after they have their battery replaced as far as battery training. Should they charge it full and drain it empty to train the battery? @jacobicare battery calibration is important to “maintain accuracy, a smart battery should periodically be calibrated by running the pack down in the device until “Low Battery” appears and then apply a recharge....

Chosen Solution Yesterday, the virus came on my mobile, I don’t have any antivirus at all in my phone… See, the virus wasn’t dangerous, I mean not dangerous as I know, but it was installing so much stupid applications itself, like battery saver, or sexy videos etc… It also showed google search when I slide down topbar(idk what is its name, the bar on top of phone, every phone has it)....

Chosen Solution Will you be including a teardown of the adapter? to reveal if there is a dac/amp in it Based on logic, it is CERTAIN that this thing does include a DAC, why? This adapter works on every iOS device since iPhone 5. If there are modifications allowing iPhone 7 to output analog signals through Lightning, the modifications certainly cannot be on iPhone 5. So the DAC has to be inside the connector....

Chosen Solution Custy brought in iPad mini 2. She said she did the repair herself, worked fine for a year and a half. Then after updating the home button stopped working. When I tested it at first, the power button isn’t working, it charges but the display won’t come on, home button still doesn’t work. Decided to put a new glass digitizer on, put it into dfu, works just fine! Except when plugged in, at first it says charging, then after a second or two, says not charging...

Chosen Solution Hi, I recently replaced the screen form my MacBook Pro 15" (Mid-2014) and now my laptop won’t close completely. When close the lid it will bounce back, with a 0.2 inch separation between the upper and lower parts. Any ideas what might have gone wrong? Are there any magnets in the screen or lower part of the case that could be malfunctioning? You’ll need to review your work as I suspect you have something caught under the hinge mount....

Chosen Solution So I opened and cleaned my ps3 today, and I made SURE that all the cables were in their respective places. Then I plugged it in and went to test it out.When I pressed the power button,the laser “Jumped a bit”(that is normal at boot,when it is testing it), so that meant that it has power. But when I pressed the sensor button to try it out,nothing happened. It’s like the sensor is not even plugged in....

Chosen Solution 2010 iMac no chime led 1& 2 on 3& 4 off and no chime Generally this is a GPU failure. Please give us the size or model number of your Mac, information is located on the bottom of your stand. UPDATE 4/25/20 Time to replace or attempt repair of your GPUcard: iMac Intel 21.5" EMC 2389 GPU Card Replacement

Chosen Solution Hi! The logic board on my 134 MacBook Pro is dead. So I’m wondering if the 2.4 A1260 logic board would fit instead of my 2.5 logic board. Thanks in advance! Here are the challenges with such a swap: The I/O board is a different model number, as printed on the board. They might be compatible, but when routing power to the entire machine, it’s a bit of a scary proposition....

Chosen Solution As the topic say, Im thinking of upgrading but Im not sure of what to buy. Atm It Wont boot up and i think its the graphics card. So i was thinking of just upgrade the logic board with something way better than what i have( base model) Is this just stupid ? Or worth it? Thinking of 800$ max. Allready have ssd and 16gig ram in it. And IF yes on upgrade what to buy?...

Chosen Solution Hi just checking how is the Wifi Antenna Diversity cable secured to the motherboard. I must have jarred it loose when I removed one of the display connectors. Looking at the pics I’m not sure if its soldiered or something else? Its the one in step 36 of iPhone 6s Plus Wi-Fi Diversity Antenna Replacement Hi Jason, At step 36, the diversity antenna cable is being disconnected from a SMA socket....