Chosen Solution I have an 80gig ipod Classic model #A1238 with a bad hard drive. What size hard drive can I install without having to change the back and battery? I know for sure that a 160 GB would fit without any problems since your model had that as an option. Anything above that, you have to make sure that the physical size is the same and that it is a zif drive....
Chosen Solution I’ve got a question regarding a Samsung J320VPP. My daughter dropped her phone and cracked the screen. There’s about 10% of the screen remaining, the rest is blacked out. I’m trying to figure out what screens are compatible with this device. On eBay there’s lcd/digitizer ranging from $28-$70-$80. When I search under SMJ320VPP it pulls up the $70-$80 replacement. If that’s the only lcd and digitizer compatible with this phone I’d rather just but my daughter a new phone....
Chosen Solution When the jets in the soap dispenser spray into the soap dispenser at the start of a cycle, the water which is going down the pipe from the bottom left of the dispenser hole is leaking. I can clearly see that the pipe which sits underneath the dispenser tray which I think is supposed to take the majority of the excess water away, is not sitting flush with the hole it sits under....
Chosen Solution LG G3 camera generates fuzzy and hazy images. I have tested the phone in warm, low, lighting and cooler, brighter lighting. Areas within the subject focus that are lighter seem to wash all other areas. HDR is off. I have tried another app (A Better Camera) and replicated the same condition. Will try another version of Android (currently on Marshmallow) and possibly a custom ROM. Will likely replace the lens cover on the rear-facing camera, but I’m wondering about whether to replace the front-facing camera....
Chosen Solution I have had personal experience with this, if you do LOCA and are not careful about it dripping into the backlight and giving a Pink hint to the screen you can do LOCA. We also remove the backlight before refurbishment and then replace the backlight back again. This is cheaper and better than OCA as well. Any issues in OCA makes it difficult for a redo but LOCA is easy to remove and clean and redo....
Chosen Solution I have an old macbook pro 13 inches model A1278. When I turn it on, there is only white screen with apple logo and a small running loop below it. When I tried install the new harddrive, there will be an apple logo but with progressive bar below it. When this progressive bar went to half point, my mac shut down and restart again. I have tried Commend + R, Commend + Option + R + P, Shift…but no help....
Chosen Solution My Mac Pro started acting weird, freezing up randomly but with long uptimes, then with increasingly shorter up times. Now won’t boot at all. Chime is also erratic. I pulled everything but the video card and keyboard. No video since it when down. At first the machine would start, no chime, optical would spin up, the main drive would spin-up, then stop, and then cycle again and repeat this cycle continuously....
Chosen Solution I have a MacBook Pro 15 “unibody A1286 late 2008 and am looking for a Magsafe DC-In Board as a spare part. On the board of my broken DC-In board is the number © 2008 820-2361-A, a spare part number of Apple, however, is not known to me. When searching the Internet I found a DC-In board, which has the same number on the board, but according to the dealer for a MacBook Pro 17 “A1297 is determined....
Chosen Solution Rubber feet on the bottom of computer came off. Can I purchase a replacement? Here’s the feet for the 15" MacBook Pro, they should work fine for you: http://www.welovemacs.com/mbp15rfeet.htm… It appears that Apple will now send you a foot-replacement kit for free if you are under warranty/AppleCare: http://support.apple.com/kb/HT5236 I spoke with their DIY dept, and they said I should expect a free kit shipped to me next-day.
Chosen Solution Hey guys, I have an old 13" MBP that’s currently completely dead. It wasn’t charging (no light on the charger) and eventually died without me being able to figure out what was wrong. The battery indicator lights work, and show an empty battery. Not able to reset SMC as it’s dead (I think, unless that happens by unplugging the battery for a while, in which case that also doesn’t work)....
Chosen Solution My MacBook pro has 500gb of hard disk and 2gb of memory with macOS Sierra installed what can be the reason for it performing slow. Easy one. Change the hard drive/IR cable out and use the 2012 models cable (see link). It gets damaged both by the rough texture where the hard drive sits on the cable and rubs and also on the last edge as it climbs the multiple steps....
Chosen Solution I have a 94 Dakota 5.2L magnum 4wd automatic tranny won’t shift from 1st to 2nd till you get 29-30mph and from 3rd to 4th at around 40-42mph not sure what to do I would have the speed sensor checked.
Chosen Solution I received a Macbook Air from a friend, it chimes, but nothing happens. I tried removing the SSD and it booted into recovery mode.I tried with a Windows Bootable USB (I had no mac media at hand) and I could reach the installation screen.I tried the SSD from another Macbook Air and it only gives me the Question Mark Folder.I rebooted into the Windows install screen and with disk part I was able to see both the USB and the SSD I used to test the machine....
Chosen Solution I have been told by any IT friend that my laptop may have a motherboard issue , can anyone tell me what I should do next, repair or buy a new one? Would the cost of repair be close to buying a new one? Like Mike said its hard to say not knowing how old or what model laptop you have but finding a motherboard for your particular laptop can be a tricky and expensive thing ....
Chosen Solution this iPhone 8 i have was stuck turning on to the apple logo screen then shutting off. when i plugged it into my computer to try and hard reset it, i only got one logo boot now its not doing anything. Any idea why or any fixes? You will need to rule out parts. So the first thing to do would be replacing the battery.
Chosen Solution Hi, about a week ago the iPhone fell on the asphalt and when I took it back, it presented the black screen with vertical lines, initially not even the sounds worked. Then in the following days, the audio started to work again, it is emitted very well both if you unlock the phone and if you also open some music files, however the screen always remains with this black background and these vertical lines....
Chosen Solution I had the same issue as described in the thread I will link below. iPhone X in bootloop, error code 4013 in iTunes and nothing would help to restore EXCEPT disconnecting the earpiece flex cable. I disconnected it and the phone booted up. However, when I reconnect the flex cable, the phone will not boot up anymore. Any suggestions? IF I connect the earpiece to the logicboard AFTER the phone is booted up, the phone continues to work and the earpiece works too....
Chosen Solution So here is another problem (along with this problem: What should a nonbroken HDD sound like/ HDD broken or battery? ) I have with my iPod: When I start hearing music, a few minutes later it starts with stutter, so the music isn’t paused but it freezes half a second and plays, freezes, plays, and a few minutes later again, it freezes complete. When I restart it, I can hear the HDD spinning up, and the mainmenu appears and for a few seconds everything works well without freezing, but right away when I hear the HDD shutting down, the iPod freezes....
Chosen Solution My G5 can’t boot and the led 3 in logic board can’t light,so I think maybe there has some problem with my logic board,and i have another working G5 model A1058 17 inch,i open it and found the logic board is the same,but i not sure,so my question is can i put the 17 inch the logic board replace the 20 inch logicboard,thanks helping me The 20" A1076 uses a 820-1747 board whereas the A1058 uses a 820-1540 board....
Chosen Solution I have a 1997 GMC sonoma, and if you take your hand, and push/pull on the drive shaft sideways, it moves probably 16th of an inch. Is this normal or doe sit mean that my middle bearing is bad (2 part drive shaft). @parzival some movement is definitely expected and 1/16th of an inch seems to be within those tolerances. Make sure that you do not get a vibration sound (thumping) while driving which would be a more common for that bearing....
