Posts

Chosen Solution when powered on the ipod A1213 shows itunes picture - should i reset ? ugyen try to hold down the home and power buttons at the same time until it shuts down and reboots. This should take it out of recovery mode. the other thing you can try is to download iReb from here and see if you can kick it out of recovery mode. Good Luck Have you managed to successfully restore your iPod using iTunes?...

Chosen Solution My iPod does not come on. When I plug the charger in, The screen comes on for a second, then it gets really hot. If you iPod still has the original factory battery, I would recommend replacing the battery first to see if that solves any issue. My first inclination would be to assume a bad logic board, but the battery is certainly a cheaper and possible fix. What is the model number printed on the back of your iPod?...

Chosen Solution I remember with older iPads and iPods we could buy flash storage or SSD or SD cards and upgrade the storage in our devices. Is this possible with the Air 2? I saw the logic board diagram and it doesn’t look possible. Has anyone figured out an alternative? It’s not possible to buy flash cards and just plug it in to work. You have to resolder the flash chip and use special equipment to rewrite chip serial data....

Chosen Solution my gameboy sp is not chargeing it not saying it chargeing in any outlit it power and work but not charge is the charge port broken or the charger is Oscar Kniepkamp yes it could be your charger or it could be the charging port. Start off by replacing the battery. Your device is getting up there is age and the battery would be the first thing to replace....

Chosen Solution I would like to know if the RAM (Random Access Memory) on the Acer Aspire One D225E upgradeable. The RAM (Random Access Memory) on the Acer Aspire One D225E is upgradeable, but only supports a single 2GB RAM module. Please note there is only one RAM slot on the D225E and supports up to 2GB of RAM only. Refer to the following link for troubleshooting information: Acer Aspire One D255E Troubleshooting...

Chosen Solution I have an HP 15-r011dx and I’m wanting to use my Canopus ADVC-100 to hook up to my old VCR to convert old VHS tapes to DVDs. Problem is: the Canopus requires a computer that has at least a Firewire 400 port. I’ve seen the firewire ports available to install for other PCs, I just have no idea where it would go on THIS PC. If anyone has any ideas I’d really appreciate the help....

Chosen Solution so i watched mulitple ( and when i say that i mean MULTIPLE x20+) videos of people just “clicking” the tabs in while replacing the whole front screen etc… with little to no prob. ok, i know i am not professional and not even close to a pro and i expect it to be somewhat more difficult than they make it look , but really!!!??Either i am completely out to lunch or these people are from another planet , with extraterrestrial- mad- almost-god-like skills in getting these ridiculously microscopic pieces to align and just “click” in....

Chosen Solution Please refer to the following image. What’s the purpose of the cable that extends from the main ribbon? Is it just there to adjust firmly the wireless charging ribbon? Or does electricity flow through it? While I was removing the battery of my iPhone XR I accidentally stretched that part, though it did not break. However I’m not sure if I should be concerned as it doesn’t seem to connect to any phone component....

Chosen Solution iMac will not power up. Fan seems to start. Any thoughts? John Celano start with this: The iMac (27-inch, Late 2009) computer has four built-in diagnostic LEDs on the main logic board that can help you to troubleshoot the computer. The LEDs are located on the bottom left edge of the logic board (under a piece of black mylar tape) and can only be seen when looking through the lower vents of the enclosure....

Chosen Solution My MJLU2LL/A A1398 seems to have fried the motherboard. it’s a 2.8GHz model. All I can find out in the wild is this board 661-0257 which says it’s compatible with MJLQ2LL/A and MJLT2LL/A models, but does not mention MJLU2LL/A. Is this compatible, or should I pass on it? Well, its not so simple! Apple produced two model versions what we call: Intergraded Graphics (IG) and Discreet Graphics (DG) To simplify things I would plug in your systems S/N into here EveryMac - Lookup to be sure....

Chosen Solution For about a week ago my MacBook Pro first started doing it, it began freezing very often and there was nothing to do other than rebooting it. So I decided to do a clean install of Snow Leopard, because maybe that would work, so I started my Mac from the Snow Leopard install disk, partioned my harddrive and installed Snow Leopard, I then rebooted. This didn’t solve anything, so I did a Apple Hardware Test....

Chosen Solution Hey all, I have tried to upgrade my MacBook with an SSD. I have opened the back plate, disconnected the battery cable, removed the HDD and inserted SSD. After that, the MacBook was dead. There is nothing, no fan spin, no beeps, no lights, nothing. I have tried with the old HDD and it’s the same. Dead. The only light I get is from magsafe. I have tried booting it up with no battery, with battery and magsafe, with HDD, SSD I have disconnected the keyboard, RAM, … don’t know what else I can try....

Chosen Solution Hi! I just repaired my Late 2013 15“ MBP. The keyboard was broken and I replaced it. The trackpad worked perfectly fine. While removing the keyboard, I ripped the trackpad cable apart. So I also replaced that with a new one too. First, the trackpad was not recognized by the computer. I then reset the bluetooth module, which seems to have fixed that. However, the mouse still doesn‘t move, and clicks don‘t get recognized....

Chosen Solution I have what appears to be a potentially very dangerous problem with my 2006 Kenmore model 721.66222500 microwave. After heating a meal this morning, the timer ended, and the meal was removed from the microwave. Upon closing the door, I noticed the microwave was still humming. But the turntable was not turning, nor was the exhaust fan running. I opened the door, put a glass of cold water inside, and closed the door again....

Chosen Solution tried to use my washer today and the timer started at 13 and locked me out of the settings how do I fix that I found out that the lid switch wiring was faulty (loose) at the circuit board after touching everything I wiggled the connector in back and this restarted the timer. my machine sits outside and it must have gotten a bad connection. because this made it work again done 5 loads and still going strong....

Chosen Solution Old Maytag still fills and agitates. The dial turns, but the water does not drain in the normal (“whites” and “colors”) cycles. It will simply start agitating again in the rinse cycle. At first this only happened with the “whites” cycle, started at least several months ago. Not really sure because I usually just wash everything in cold water anyway, using the “colors” cycle. Now it’s happening with the “colors” cycle too....

Chosen Solution Where could I purchase a metal tip for the top of my wooden handle/tip umbrella? In Australia Hi @neets61 , Search for umbrella ferrules to find suppliers. Here is a link to one supplier to give you an idea

Chosen Solution A MBA early 2014 that suffered liquid damage. I just replaced the motherboard and the IO board. The witness dot on the cable between 2 boards is red, but still functional. However, the microphone connection shows strong corrosion on the replaced IO board; and the microphone connection cable is also little damaged. The microphone doesn’t work. Has anyone ever changed the microphone? Here’s the IFIXIT guide you’ll need to work off of MacBook Air 11" Early 2014 Upper Case Replacement Follow the first steps stopping at Step3, then jump to Step12 & 13 removing the battery....

Chosen Solution Kenmore Microwave model 401.8504*,85143 Whenever door is opened the fan (I think it’s the fan) is running Bad sensor/switch within the microwave. Latch body and switch assy. part number DE96-00414A needs replaced. The latch body and switch assembly DE96-00414A comes with the switches that monitor the door position and the latch body that holds the switches in place so the switch is bad causing the unit to not detect the stopped state....

Chosen Solution Hi, I dropped my phone and my motherboard has now stopped working, the local phone shop has said this needs replacing but they do not do this. Does anyone know where in the West Midlands (UK) I could try? My only pictures of my late nephew are on this phone and it didn’t pick it up on a backup as the storage data was not big enough to do so...