Chosen Solution There was a power surge and PS4 was plugged in. Apparently the transformer inside it burnt. The PS4 doesn’t switch on and shows no sign of life. I have a PS3 that i don’t use anymore, so is a PS3 transformer part same as the PS4 one? And if yes, can i install it into the PS4? @jobizi no you cannot. The PS3 and PS4 power supplies are different....
Chosen Solution Hi there, i´d like to have an other colour in the back and menue keys. Is it possible to change the (i bet its only a single one) led behind them? You don´t open the galaxy s2 this far. Thank you for your Answers. Greets Kevin if you can open your phone to the led then you should be able to desolder and resolder any colour you like…finding one the same size is the only problem....
Chosen Solution Purchased the new iMac Retina two days ago and spent yesterday finding a good Samsonite hard-shell suitcase to transport it with me on a flight, like i have done with my 2009 iMac 27 for years. Found the perfect case for it, but my heart sank when i inserted an old credit card into the slot above the stand and found that nothing happened. I did a few searches online and found conflicting info, where some say that it will not remove, and others say that like the 2014 non-Retina, it will remove....
Chosen Solution How to test if my relays are bad? relays are essentially an electronic switch, when a voltage is applied to the coil it will close the switch when it is removed it will open (normally open relay), without going into too much detail the type of relay youre talking about would be set up to cut its own power supply to make the light flash, as such if it is working you should be able to hear it clicking in and out, if it inst (with you’re multi meter in dc mode because its being fed by a battery) check there is power getting to it, if there is then you would expect continuity (complete circuit) through one side when the coil is energised and not the other and vice versa when it is de energised - but if you’re not familiar with electrics i would just listen for the clicking, if its not clicking its either not getting power for some reason or its stuck/burned
Chosen Solution My mac quit working (it won’t turn on) after the power in our house flickered the other day. Is there an internal fuse that might have tripped or should I check the power supply module? SMC RESET Shut down the computer. Unplug the computer’s power cord from both the wall and computer. Wait 15 seconds. Attach the computers power cable. Wait another 5 seconds and press the power button to turn on the computer....
Chosen Solution Hi, I broke my screen that is completely shattered so I removed the screen/lcd after seeing your instructions (till step 18 here iPhone 7 Plus LCD and Digitizer Replacement ). If I just connect ((steps 14 to 18 in reverse direction)) any new screen connectors to phone without transferring anything from broken screen to new screen (earpiece, home button, speaker etc.), can I switch-on phone for backing-up my data assuming nothing else is damaged in the phone?...
Chosen Solution My son spilled apple juice on his computer near the upper left side. Screen would not work. External monitor worked. He dissassembled and cleaned the contacts - the screen then worked. It worked for a month or so. Now it won’t even power on. Replace MagSafe DC-In Board. Still will not work. Any help would be greatly appreciated. Hi, Its possible some juice was missed and would be very damaging to the internals....
Chosen Solution Can i change the logic board of the late 2013 13" (i5 with 8gb of ram) with the new logic board of the mid 2014 13" (i7 and 8 or 16 gbs of ram)? Do they have the same pins and size? If yes, would i have problems with any drivers? are the parts the same? The new installations of the OS will have problems? Did anyone change the logic board?...
Chosen Solution No red in phone display. When phone boots red color shows in logo, but then changes to gray. After boot finishes there is no red in display. Hi, Try starting the phone in safe mode To enable safe mode: Ensure that the phone is Off. Press and hold the Power key operated When “Blu” logo is displayed, release the Power key. Immediately after releasing the Power key, press and hold the Volume Down key....
Chosen Solution I have a galaxy s8 european model. I tried to install different model firmware and i lost imei and baseband. Now i cant make calls and my imei number in settings is unknown. Can someone please tell me how can get it back to normal. Look for your “CARRIER_ID: XXX” which you can find when you put the phone into download mode (Power + Bixty + Vol down) Once you have the 3 letter code that is the CSC (Sales / Region code)....
Chosen Solution My sister has lost my usb to my wireless mouse model FHA-3510 an I’m tryn to find out if it can be replaced cuz my mouse matches my computer an don’t really want to get an new mouse Have you tried HP parts dept. While a long shot I’ve been surprised! Even if they don’t have a spare unit you could ask them if other current models use the same USB transceiver unit (they should also be able to tell you all of the models that used it)....
Chosen Solution I tried to replace the ram in my Macbook Pro with upgraded ram. It had 4gb already. After putting in new ram, it would not complete the boot sequence but just came up with “You need to power down your computer now. Press the power button…..” I replaced it with the original 4gb ram and tried again and now, it will not boot, but just returns to the same msg to power down the computer....
Chosen Solution Hello, my mac book pro was exposed to water(some drop of rain) while it was on. It was OK for some minutes, than suddenly it asked me if I wanted to restart the system and immediately shut down. When back home I disassembled it (logic board etc… trough the keyboard) and tryed to dry it, but no visible water was inside if not one water drop on the battery....
Chosen Solution Hi, can anyone tell me if I can still buy a MacBook 11,4 15" Retina (Mid 2015) MagSafe DC-In Board. Thanks yes, if you look at the dc in board there should be a part number. enter it into google and it should show them
Chosen Solution Hello, I have a MacBook Retina early 2016 which I tried to reinstall the OS on however it told me there was no starting disk, how can I get one or install one? This MacBook has a soldered SSD and RAM, and no disk slot so I’m guessing its something I have to install. Thank you for your help Looks like you can boot into recovery mode. First run Disk Utility and see if you can repair the storage unit....
Chosen Solution My MacBook Pro 13" froze the other day when I tried to open my web browser. I tried just waiting a little while to see if the problem might sort its self out, but after about twenty minutes I decided to power down the laptop and just try rebooting. Since then whenever I power on the laptop it goes through the white loading screen, then goes to a blue screen for quite a while, and then to my desktop background image....
Chosen Solution I tried to update HDD yesterday. While that procedure, the rubber with holds HDD has moved and I could not get the HDD back in. So I gone mad and tried to remove the rubber with a knife. Took long time and I have not always hit the rubber but the metal of HDD shaft. May I cause s short circuit of LogicBoard? It seems unlikely that the problem you encountered with the HDD hurt the logic board....
Chosen Solution Engine on my Model 917274040 starts and runs when brake is depressed and PTO (mower blades) is not engaged. Releasing brake or engaging PTO with brake depressed immediately cuts off engine (electrical cut off). Replaced the brake safety switch, but same symptoms. Brake safety switch was difficult to install and I may have damaged the new switch installing it (installation help?). Don, consider bypassing the safety switch for TESTING PURPOSES only to see if your mower works....
Chosen Solution Hello. My iphone is suddenly very dim (vignette) on the upper left corner. If I go 50% brightness, the upper left portion is stuck at around 15%. Just brought it 1 month ago from a friend, no issues until now. I didn’t drop it or no water damage. It was fine when I put it on the bag and then when I try to use it again, the problem is already there....
Chosen Solution My battery on iPod Video 30Gb died, so i replaced for a new one. But my iPod wont charge throught the usb 2.0 ports on my Mac, tried the block charger and that doesnt work. I tried another new battery and the same problem. I tired a new cable same results. any ideas? I would at first check the voltage of the batteries with a multimeter. if the voltage is to low - it wont charge (usb) or could take long to show sings of charging (wall charger)....
